Forum Thread

Port Saint Joe - Mexico Beach Topics

(Port Saint Joe - Mexico Beach Specific)

1 messages

Updated 2/16/2011

Off-Topic

Lakes Online Forum

83,667 messages

Updated 6/12/2024 8:53:24 AM

Boat Maintenance

Lakes Online Forum

5,197 messages

Updated 6/10/2024 5:39:11 AM

Port Saint Joe - Mexico Beach Fishing

(Port Saint Joe - Mexico Beach Specific)

1 messages

Updated 2/16/2011

Jokes

Lakes Online Forum

4,170 messages

Updated 6/10/2024 6:29:37 PM

Sports

Lakes Online Forum

4,261 messages

Updated 5/28/2024 6:31:10 AM

Grilling & Recipes

Lakes Online Forum

2,977 messages

Updated 6/10/2024 6:30:23 PM

Tallapoosa River Topics

Lakes Online Forum

98 messages

Updated 4/15/2024 1:00:58 AM

Forum Usage Rules

Name:	slownez -	Reply
Subject:	Trim Gauge Needle Stuck in full up position.
Date:	4/8/2010 9:28:50 AM

Cat, Pulled my boat from storage this year and found the Trim Gauge Needle Stuck in full up position. I check the wiring to the gauge and it looks good. Before ordering a new gauge, where should I check next? Does the gauge get the reading from the throttle control trim control, or is there a sensor on the motor? It's a Yamaha 150 outboard. Thanks for any help. Steve

Name:	CAT BOAT -	Reply
Subject:	Trim Gauge Needle Stuck in full up position.
Date:	4/8/2010 1:18:53 PM

I am not sure where the sensor is located on a Yamaha OB. If I were to guess, I would look at the rotation/trim pin at the back of the engine? I'll do some research.

Name:	BIGAL84 -	Reply
Subject:	Trim Gauge Needle Stuck in full up position.
Date:	4/8/2010 9:38:59 PM

I have a Yamaha 150 HPDI and it has the same problem. I found the sensor on the motor and checked it with an ohm meter and it was ok. I found a lever that rides on the sensor broken, its made of plastic. Went to the Yamaha place to get a new one and got an upgraded metal one from them. have not replaced yet. It is real hard to see the sensor up under the motor.

Hope this helps

Name:	slownez -	Reply
Subject:	Trim Gauge Needle Stuck in full up position.
Date:	4/9/2010 10:47:01 AM

Thank you so much, can you give me any more detail on the exact location of the sensor? May pull up on a sandbar today and wade in the cold water to find it.

Name:	Rooster -	Reply
Subject:	Trim Gauge Needle Stuck in full up position.
Date:	4/9/2010 4:21:19 PM

Follow the wires- tucked up between the two piston arms I believe.

Quick Links
Port Saint Joe - Mexico Beach News
Port Saint Joe - Mexico Beach Photos
Port Saint Joe - Mexico Beach Videos