Forum Thread
(Tenkiller Ferry Lake Specific)
0 messages
Updated
Lakes Online Forum
84,070 messages
Updated 10/30/2024 8:48:25 AM
Lakes Online Forum
5,204 messages
Updated 9/14/2024 10:10:50 AM
(Tenkiller Ferry Lake Specific)
0 messages
Updated
Lakes Online Forum
4,172 messages
Updated 9/9/2024 5:04:44 PM
Lakes Online Forum
4,261 messages
Updated 5/28/2024 6:31:10 AM
Lakes Online Forum
2,979 messages
Updated 6/26/2024 5:03:03 AM
Lakes Online Forum
98 messages
Updated 4/15/2024 1:00:58 AM
Tenkiller Ferry Lake Photo Gallery





    
Name:   slownez - Email Member
Subject:   Trim Gauge Needle Stuck in full up position.
Date:   4/8/2010 9:28:50 AM

Cat, Pulled my boat from storage this year and found the Trim Gauge Needle Stuck in full up position. I check the wiring to the gauge and it looks good. Before ordering a new gauge, where should I check next? Does the gauge get the reading from the throttle control trim control, or is there a sensor on the motor? It's a Yamaha 150 outboard. Thanks for any help. Steve



Name:   CAT BOAT - Email Member
Subject:   Trim Gauge Needle Stuck in full up position.
Date:   4/8/2010 1:18:53 PM

I am not sure where the sensor is located on a Yamaha OB. If I were to guess, I would look at the rotation/trim pin at the back of the engine? I'll do some research.



Name:   BIGAL84 - Email Member
Subject:   Trim Gauge Needle Stuck in full up position.
Date:   4/8/2010 9:38:59 PM

I have a Yamaha 150 HPDI and it has the same problem. I found the sensor on the motor and checked it with an ohm meter and it was ok. I found a lever that rides on the sensor broken, its made of plastic. Went to the Yamaha place to get a new one and got an upgraded metal one from them. have not replaced yet. It is real hard to see the sensor up under the motor.

Hope this helps



Name:   slownez - Email Member
Subject:   Trim Gauge Needle Stuck in full up position.
Date:   4/9/2010 10:47:01 AM

Thank you so much, can you give me any more detail on the exact location of the sensor? May pull up on a sandbar today and wade in the cold water to find it.



Name:   Rooster - Email Member
Subject:   Trim Gauge Needle Stuck in full up position.
Date:   4/9/2010 4:21:19 PM

Follow the wires- tucked up between the two piston arms I believe.







Quick Links
Tenkiller Ferry Lake News
Tenkiller Ferry Lake Photos
Tenkiller Ferry Lake Videos




About Us
Contact Us
Site Map
Search Site
Advertise With Us
   
TenkillerFerry.USLakes.info
THE TENKILLER FERRY LAKE WEBSITE

Copyright 2024, Lakes Online
Privacy    |    Legal